XM Radio volume too low
#1
Rookie
Thread Starter
XM Radio volume too low
Just got the XM trial started for my CPO 2010 LS 460 with the Nav/ML option. I noticed the volume is very low when playing satellite radio. When playing FM or a CD, it's much louder. Kinda blows you away when switching from XM to FM or a CD.
Just turned off the speed sensitive volume, but didn't try switching. So I don't know if this will help.
Any one else have this issue?
Thanks,
Dana
Just turned off the speed sensitive volume, but didn't try switching. So I don't know if this will help.
Any one else have this issue?
Thanks,
Dana
Last edited by dfrosch; 04-06-15 at 11:43 AM. Reason: more info
#2
What you are experiencing may be an indication that the SAT equalizer is set to minimum, or that the AM and FM equalizers are set to maximum, or both. The equalizers for AM, FM and SAT are independent settings.
You should leave the ASL on.
You should leave the ASL on.
#3
Rookie
Thread Starter
The equalizers were set just one tick differently on the bass. This isn't enough to explain the drastic difference in sound level.
But thanks, didn't know there were separate equalizers.
Last edited by dfrosch; 04-06-15 at 03:05 PM. Reason: thanks
#5
Rookie
Thread Starter
Talked with Sirius CS for about 30 minutes on Monday. They resent the signal a couple times. Can't say that it helped much, if any.
May end up just setting the equalizers to get the same volume...
May end up just setting the equalizers to get the same volume...
#6
I've noticed the same issue in my recently purchased '11 CPO -- specifically, the XM and BT Audio volume is much lower than the other sources. And yes, my equalizer settings are the same as it is for other sources and ASL is on. I guess I'm trying to figure out if this behavior is typical in all ML systems or if I need something replaced.
#7
Pole Position
I've noticed the same issue in my recently purchased '11 CPO -- specifically, the XM and BT Audio volume is much lower than the other sources. And yes, my equalizer settings are the same as it is for other sources and ASL is on. I guess I'm trying to figure out if this behavior is typical in all ML systems or if I need something replaced.
Last edited by Unsober1; 07-21-15 at 06:42 PM. Reason: Spelling correction
Thread
Thread Starter
Forum
Replies
Last Post
inrainbows
Lexus Audio, Video, Security & Electronics
1
01-24-08 02:57 PM