Today was a good day
#1
Driver
Thread Starter
#2
Forum Administrator
iTrader: (2)
Congratulations! Nice way to head into the weekend.
Trending Topics
#8
Driver
Thread Starter
Thanks, everybody!
It was shipped from Palm Springs to a dealer auction in Riverside where I bought it. Then it shipped from there to Bellingham, WA. It's not cheap or fast to do, but it was worth it to get the right car.
It's a 2002 custom luxury package with 105k miles, tons of service history, clean title, no accidents. It is mystic sea opalescent with the Ecru perforated leather and blackwood interior.
My first steps with it are to have it checked out for any maintenance needs (nothing major expected), detail it, and get PDR done on a couple door dings. In a brief inspection this morning, it didn't look like anything would need paint work to make it look good as new.
It was shipped from Palm Springs to a dealer auction in Riverside where I bought it. Then it shipped from there to Bellingham, WA. It's not cheap or fast to do, but it was worth it to get the right car.
It's a 2002 custom luxury package with 105k miles, tons of service history, clean title, no accidents. It is mystic sea opalescent with the Ecru perforated leather and blackwood interior.
My first steps with it are to have it checked out for any maintenance needs (nothing major expected), detail it, and get PDR done on a couple door dings. In a brief inspection this morning, it didn't look like anything would need paint work to make it look good as new.
#9
#11
Driver
Thread Starter
Took her for a drive at lunch and I'm impressed! So far the repair needs look like:
- Subwoofer sounds like it's blown. Going to get it out and see if it can be refoamed or if i need a new one. I hear they are absurdly expensive.
- Power folding doesn't work on the right side mirror.
- Wiper blades were shot, so I put some new OEM ones on.
- Trunk struts are worn out. Looks like they're $132 each so I might wait a bit on those.
- Two very small door dings that I'll have PDR'd out.
- In need of headlight lens restoration. I worked as a detailer for a few years so that's no big deal.
I'm hoping to get this into perfect condition since I'm very picky about my cars.
-Oh and it probably needs seat air filters
- Subwoofer sounds like it's blown. Going to get it out and see if it can be refoamed or if i need a new one. I hear they are absurdly expensive.
- Power folding doesn't work on the right side mirror.
- Wiper blades were shot, so I put some new OEM ones on.
- Trunk struts are worn out. Looks like they're $132 each so I might wait a bit on those.
- Two very small door dings that I'll have PDR'd out.
- In need of headlight lens restoration. I worked as a detailer for a few years so that's no big deal.
I'm hoping to get this into perfect condition since I'm very picky about my cars.
-Oh and it probably needs seat air filters
#12
Lexus Fanatic
iTrader: (1)
You can use an aftermarket sub. Just stick with one that is at least 8 ohms. Factory is between 12 - 16. I searched around and found an OEM for about $200 when I did mine. Very common for the sub to go. Also, 04's had issues with the door speakers degrading too.
http://www.ebay.com/itm/like/331269238134?lpid=82
http://www.ebay.com/itm/like/331269238134?lpid=82
Last edited by Lavrishevo; 08-14-14 at 01:51 PM.
#13
Driver
Thread Starter
You can use an aftermarket sub. Just stick with one that is at least 8 ohms. Factory is between 12 - 16. I searched around and found an OEM for about $200 when I did mine. Very common for the sub to go. Also, 04's had issues with the door speakers degrading too.
New Factory 2004 2006 Lexus LS430 Mark Levinson Rear Subwoofer Speaker 2005 | eBay
http://www.amazon.com/Monroe-901633-...ype=automotive
New Factory 2004 2006 Lexus LS430 Mark Levinson Rear Subwoofer Speaker 2005 | eBay
http://www.amazon.com/Monroe-901633-...ype=automotive
#14
Pole Position
I did re-foam on sub-woofer and front door woofers on my '01 and it sounds fine at full volume. If you decide to replace the sub on the rear package tray, get a 8 ohm dual voice coil sub so that can be wired in series for 16 ohm = OEM impedance.