Benefit to Air Box Mod???
#16
Lead Lap
iTrader: (1)
Some would argue that...
What was K&N smoking when they finally put them side by side. It should have went back to the drawing board. They should do a redesign with an element in the center. There must be some documentation proving better air flow with what's pictured above. I bought it because its 'supposed' to be better. It certainly doesn't add much 'noise', I found it noticeble only above 4500 rpm.
On the topic of intakes... I know the 98-00 air inlet tube has a built in resonance chamber. It's noticible on the underside. If this is blocked/closed off, I assume induction sound should be louder ?
What was K&N smoking when they finally put them side by side. It should have went back to the drawing board. They should do a redesign with an element in the center. There must be some documentation proving better air flow with what's pictured above. I bought it because its 'supposed' to be better. It certainly doesn't add much 'noise', I found it noticeble only above 4500 rpm.
On the topic of intakes... I know the 98-00 air inlet tube has a built in resonance chamber. It's noticible on the underside. If this is blocked/closed off, I assume induction sound should be louder ?
#17
BahHumBug
iTrader: (10)
Some would argue that...
What was K&N smoking when they finally put them side by side. It should have went back to the drawing board. They should do a redesign with an element in the center. There must be some documentation proving better air flow with what's pictured above. I bought it because its 'supposed' to be better. It certainly doesn't add much 'noise', I found it noticeble only above 4500 rpm.
On the topic of intakes... I know the 98-00 air inlet tube has a built in resonance chamber. It's noticible on the underside. If this is blocked/closed off, I assume induction sound should be louder ?
What was K&N smoking when they finally put them side by side. It should have went back to the drawing board. They should do a redesign with an element in the center. There must be some documentation proving better air flow with what's pictured above. I bought it because its 'supposed' to be better. It certainly doesn't add much 'noise', I found it noticeble only above 4500 rpm.
On the topic of intakes... I know the 98-00 air inlet tube has a built in resonance chamber. It's noticible on the underside. If this is blocked/closed off, I assume induction sound should be louder ?
In terms of sound though, it doesn't quiet the intake so much as it reduces drone at select rpm.
#18
Lead Lap
iTrader: (1)
So a while back I did my version of the 2 known intake mods. The filter pod has a half cut on the bottom edge. I removed the resonance chamber as discussed above & Gorilla taped the holes. Completed a custom fit heat shield sealing off the air box compartment. It fits pretty snug & protected any edge that came in close contact to components around it. I also removed most of the headlight gasket for fresh air. Now it sounds much better & seems to rev more freely.
Last edited by VanCityLS4; 05-26-13 at 11:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
1995LS400
LS - 1st and 2nd Gen (1990-2000)
6
03-12-08 09:31 AM