Will My Set Up Work
#1
Driver School Candidate
Thread Starter
Will My Set Up Work
Hey guys, i'm new here and have a few questions. I have an Is250 awd 2009. I wanted to know would this set up work for my car. Right now i'm running 17x7 all round (oem)
Will this set up work?
19x8.5+35 (enkei rainjin)
235/35/19 (hancook v12)
That's the front
19x9.5+35 (enkei rainjin)
275/30/19 (hancook v12)
The rear
Will i need spacers? And i'm getting ex Coilovers soon. I already have the rims
Will this set up work?
19x8.5+35 (enkei rainjin)
235/35/19 (hancook v12)
That's the front
19x9.5+35 (enkei rainjin)
275/30/19 (hancook v12)
The rear
Will i need spacers? And i'm getting ex Coilovers soon. I already have the rims
#4
Driver School Candidate
Thread Starter
#7
Lexus Test Driver
iTrader: (3)
People say that the "rolling diameters" need to be the same, but eventually people reported running into problems....
Just to be on the safe side I went with a "square" setup.
As for lowering, I was advised of the "25" fender to ground safe zone".... this gets rid of the god awful wheel gap, but also saves your axles... play around with a height until vibrations are minute or absent.
Good luck!
Just to be on the safe side I went with a "square" setup.
As for lowering, I was advised of the "25" fender to ground safe zone".... this gets rid of the god awful wheel gap, but also saves your axles... play around with a height until vibrations are minute or absent.
Good luck!
Trending Topics
#10
Driver School Candidate
Thread Starter
I already have the rims but I'm waiting for next paycheck for the coilovers.
#11
Driver School Candidate
Thread Starter
So far so good.
So I ended up going with 235/35 fronts and 265/30 dws continental with my enkei. The front driver side rubs but it's not a big rub. I did not install my coilover yet. I ended up with Megan Racing PL
Thread
Thread Starter
Forum
Replies
Last Post
gcomme2
IS - 2nd Gen (2006-2013)
10
11-15-15 06:02 AM