I accidentally snapped a bolt on my coolant inlet housing, am I screwed?
07-22-23, 02:26 PM
#1
8th Gear
Thread Starter
Join Date: Aug 2021
Location: 32257
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
I accidentally snapped a bolt on my coolant inlet housing, am I screwed?
Did the classic 1 crank too many and snapped a 10mm bolt on the bottom of my water inlet housing. Of course on the practical last step of replacing my water pump this happens. Am I completely screwed until I can get a new one? Will it still seal without the one bolt? If not what is methods can I use to get the old bolt out?
Thread
Thread Starter
Forum
Replies
Last Post
AceWright
SC430 - 2nd Gen (2001-2010)
15
04-23-22 01:31 PM
trips1
RX - 1st Gen (1999-2003)
14
06-02-17 10:06 AM