Aftermarket HID Leveling Question
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2008
Location: NC
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Aftermarket HID Leveling Question
To everyone that put in aftermarket HID kits how are the halogen projectors? It's my understanding that halogen projectors are different than HID projectors..... Without the auto leveling isnt it blinding?
Lastly to the ones that have done the Xenon depots Xtreme kits do their rubber grommets behind the blubs provide an adequate tight seal in the headlight housing?
Lastly to the ones that have done the Xenon depots Xtreme kits do their rubber grommets behind the blubs provide an adequate tight seal in the headlight housing?
#2
Lexus Champion
iTrader: (7)
Join Date: Mar 2008
Location: NorCal 2IS/BayArea
Posts: 1,800
Likes: 0
Received 0 Likes
on
0 Posts
I just did my conversion 2 weeks ago. Both the lows h11 and fogs 9006.
Their is a cut off and it is very straight across. I adjusted it to go higher using my garage door to level. And driving around the block using parked cars to see if the cutoff is below the dash. The left side cut off is lower than the right side I noticed from factory setting. But the forum says that is default so you dont blind anyone coming towards you. But when I drive on the road the beams looks neat and tidy with very if any noticable glaring. I had my friend drive towards me and said that they look sharp and did not get any glare look. I went with the 5000k to get a oem look as much as possible.
Their is a cut off and it is very straight across. I adjusted it to go higher using my garage door to level. And driving around the block using parked cars to see if the cutoff is below the dash. The left side cut off is lower than the right side I noticed from factory setting. But the forum says that is default so you dont blind anyone coming towards you. But when I drive on the road the beams looks neat and tidy with very if any noticable glaring. I had my friend drive towards me and said that they look sharp and did not get any glare look. I went with the 5000k to get a oem look as much as possible.
Thread
Thread Starter
Forum
Replies
Last Post