Custom rear fender flare IS350
#1
Driver
Thread Starter
Custom rear fender flare IS350
Whats up CL! Its been a while since i posted on the forum but believe that i have been busy! I finished up my rear wide fender to clear my wheels and I thought I would share with you guys. LMK what you guys think! Here is a link to my Facebook business page also! Please like and share
https://www.facebook.com/TheEmpireGarage?ref=hl
https://www.facebook.com/TheEmpireGarage?ref=hl
Last edited by AutoSexy13; 07-16-13 at 09:04 AM.
#4
Lexus Test Driver
That looks so good, I've been wanting to do this with my car for a while now but I've just dealt with it and found ways to get around doing it. This makes me want to flare my fenders really bad though.
#6
Driver
Thread Starter
RCVA its really simple to do actually and took me about 3 days to complete it beginning to end. I basically cut along the seam, pulled it out, welded the lip back together and on the inside where it meets the frame for structural rigidity and used 18g sheet metal to form it. Its highest point was extended 1.5" and at 40-45 degrees from center on both sides were extended 1.25" to get it to flow properly. I will get some more shots of the rear soon!
Trending Topics
#10
Driver
Thread Starter
Yep i sure did RVCA. I have a shop here in albuquerque NM and we do custom fabrication, auto repair, and paint and body. Next project soon will be a custom twin plenum intake manifold with built in velocity stacks for the IS350. That will be another thread though when i get to it!
#14
Lead Lap
iTrader: (2)
Yep i sure did RVCA. I have a shop here in albuquerque NM and we do custom fabrication, auto repair, and paint and body. Next project soon will be a custom twin plenum intake manifold with built in velocity stacks for the IS350. That will be another thread though when i get to it!