Hybrid Technology Unique topics related to the 2004 -2009 RX400H model hybrid drivetrain and other features/options found only on the RX400H. Please use the main forum for discussion about shared components with other second generation RX models.

Looking to tap power, passenger floorboard area...

Thread Tools
 
Search this Thread
 
Old 12-03-06, 03:07 AM
  #1  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default Looking to tap power, passenger floorboard area...

Anyone have schematics of best power options for this location? Need switched power, could be close to the center console, prefer right side footwell.

Any schematics or pics before I start pulling panels?
Old 12-03-06, 04:07 PM
  #2  
larrytrk
Pit Crew
 
larrytrk's Avatar
 
Join Date: Nov 2005
Location: MA
Posts: 170
Received 16 Likes on 15 Posts
Default

Originally Posted by Plug Guy
Anyone have schematics of best power options for this location? Need switched power, could be close to the center console, prefer right side footwell.

Any schematics or pics before I start pulling panels?
(Cigarette lighter) is switched, easy accessed.
Can easily run to passenger footwell, where My Vaistech I-pod is or center console.
Eric, is that you?
Old 12-03-06, 06:08 PM
  #3  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by larrytrk
(Cigarette lighter) is switched, easy accessed.
Can easily run to passenger footwell, where My Vaistech I-pod is or center console.
Eric, is that you?
T'is I.

Yes, was thinking of tapping the lower lighter socket, just not 100% sure what sensors, if any are below the carpet and how easy it is accessed. Need to tap wires, not lighter socket itself. Thanks!
Old 12-03-06, 07:30 PM
  #4  
larrytrk
Pit Crew
 
larrytrk's Avatar
 
Join Date: Nov 2005
Location: MA
Posts: 170
Received 16 Likes on 15 Posts
Default

Lift up and take off the boot for gear shift and the entire socket and seat heater board pops out for easy access for the wires. This is how you remove radio and nav units. This part is a snap..
how's the 997 i-pod coming along?
PM me for further info, if necessary!!
Here is additional link:Hope it works
https://www.clublexus.com/forums/sho...72#post1697772
You DO NOT have to remove shift ****.

Last edited by larrytrk; 12-03-06 at 07:40 PM.
Old 12-04-06, 04:42 PM
  #5  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default

Holy smokes, THAT is some diagram work.

I was thinking about tapping the FLOOR lighter socket instead though.
Old 12-04-06, 07:08 PM
  #6  
larrytrk
Pit Crew
 
larrytrk's Avatar
 
Join Date: Nov 2005
Location: MA
Posts: 170
Received 16 Likes on 15 Posts
Default

Originally Posted by Plug Guy
Holy smokes, THAT is some diagram work.

I was thinking about tapping the FLOOR lighter socket instead though.
AAH!! NEVER MIND!
Seriously, what are you powering?
I Don't know an easy way to get to the lower one!
Old 12-12-06, 11:40 AM
  #7  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default

V-1. Doing it tonight, I think. We will probably tap lower power rather than do that entire console.
Old 12-12-06, 02:27 PM
  #8  
larrytrk
Pit Crew
 
larrytrk's Avatar
 
Join Date: Nov 2005
Location: MA
Posts: 170
Received 16 Likes on 15 Posts
Default

Very easy to tap into sun roof motor circuit. That is where my passport was easily wired!! small length of wire to mount unit up top, either next to or under mirror!!
Old 12-12-06, 06:28 PM
  #9  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks Larry.....we're doing it tomorrow instead, upper power off sunroof/mirror area. Unit is already in, I prefer it right of rearview mirror.

Old 12-13-06, 04:30 AM
  #10  
larrytrk
Pit Crew
 
larrytrk's Avatar
 
Join Date: Nov 2005
Location: MA
Posts: 170
Received 16 Likes on 15 Posts
Default

After tapping into wire if sunroof doesn't operate correctly, you may have to reinitialize by opening and closing a few times. I thought I screwed something up and had to call service just to find out.
Old 12-13-06, 06:39 PM
  #11  
Plug Guy
Rookie
Thread Starter
 
Plug Guy's Avatar
 
Join Date: Nov 2006
Location: NC
Posts: 58
Likes: 0
Received 0 Likes on 0 Posts
Default

Tapped it from above, inside the lighting module. Took 10 minutes. Done. Perfect.

Now if we can eliminate the light surging problem that crept up at the beginning, we should be ok.

One other thing I noticed tonight driving it...while braking, it pulls left. Hmmm.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Zoraone
LS - 1st and 2nd Gen (1990-2000)
17
11-24-12 01:23 AM
UO duck IS
IS - 1st Gen (2001-2005)
1
07-26-06 10:44 PM
EBMCS03
IS - 2nd Gen (2006-2013)
5
05-31-06 08:07 PM
wayner
IS - 2nd Gen (2006-2013)
39
03-10-06 07:21 PM
cschow
LS - 1st and 2nd Gen (1990-2000)
5
05-20-04 12:10 PM



Quick Reply: Looking to tap power, passenger floorboard area...



All times are GMT -7. The time now is 02:46 AM.