Memory seat not working after doing door actuator
#1
Pole Position
Thread Starter
Memory seat not working after doing door actuator
Hi all,
I fixed my front driver side door actuator last week and my memory seat buttons are not working now. I reopened the door linning again and replugged in the plug and check the fuse box down by the foot well and didnt see any blown fuse.
Is there any where I can check?
Thanks!
I fixed my front driver side door actuator last week and my memory seat buttons are not working now. I reopened the door linning again and replugged in the plug and check the fuse box down by the foot well and didnt see any blown fuse.
Is there any where I can check?
Thanks!
#3
Pole Position
Thread Starter
ooops!
#4
Driver School Candidate
Join Date: Oct 2014
Location: ky
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Get this, I just did both front door acuators over the weekend, I disconnected my battery, and when I got the job done and went to drive the car, I got a p1128 CEL and the car would not accelerate unless you put the pedal to the floor. Had to order a throttle control motor to fix the problem. It blows my mind just by disconnecting the battery it causes the TCM to fail.
#5
Pole Position
Thread Starter
Get this, I just did both front door acuators over the weekend, I disconnected my battery, and when I got the job done and went to drive the car, I got a p1128 CEL and the car would not accelerate unless you put the pedal to the floor. Had to order a throttle control motor to fix the problem. It blows my mind just by disconnecting the battery it causes the TCM to fail.
Thread
Thread Starter
Forum
Replies
Last Post
UZ214
LS - 3rd Gen (2001-2006)
8
10-02-13 07:38 PM