GS - 2nd Gen (1998-2005) Discussion about the second generation GS300, GS400 and GS430 (1998 - 2005)

HELP!!! Gs won't start and has no spark!

Thread Tools
 
Search this Thread
 
Old 08-01-13, 09:11 AM
  #1  
Flupmike22
Driver School Candidate
Thread Starter
 
Flupmike22's Avatar
 
Join Date: Jul 2013
Location: Nv
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default HELP!!! Gs won't start and has no spark!

Ok guys I need help ASAP because this cars my daily.
I was at bumper to bumper traffic and as I accelerated car did a hàlf second sputter. Instantly I thought she overheated. But the temp gauge was normal. She cranks all day but I pulls the wires and there's no spark. Here's what I already ruled out.

Check all the fuses and everything is fine.
I replaced the efi relay and it did the same thing.
My cousin has the same exact car so I swapped the igniter with him and still no spark.
I swapped the relay that says engine I think and still no spark. The fuse that says engine main is still fine. I checked only the front and rear coil packs because the middle one is blocked by the intake.(still would safely assume the middle coil is out also. Now as far as timing I checked briefly. The 2 cam gears were both still in the matching positions to each other so I assumed the timing was set right.

Can anyone help me with this? I need to get this sucker fixed now!
Old 08-01-13, 09:24 AM
  #2  
damiendada
Rookie
 
damiendada's Avatar
 
Join Date: Jul 2013
Location: NS
Posts: 70
Likes: 0
Received 0 Likes on 0 Posts
Default

Check engine codes. Could be Crank sensor.
Old 08-01-13, 09:39 AM
  #3  
mexikan
Driver
 
mexikan's Avatar
 
Join Date: Mar 2011
Location: CA
Posts: 168
Received 1 Like on 1 Post
Default

I had the same problem turned out to be the fuel pump, you can check by spraying carb cleaner in the intank and crank it to see if it starts.. hope this helps
Old 08-01-13, 09:46 AM
  #4  
Flupmike22
Driver School Candidate
Thread Starter
 
Flupmike22's Avatar
 
Join Date: Jul 2013
Location: Nv
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default

Fuel pump still works I can hear it. There's clearly no spark. And I don't have a scanner. And I thought cam sensor and cps would only make it run like ****. But she should idle some.
Old 08-01-13, 10:29 AM
  #5  
damiendada
Rookie
 
damiendada's Avatar
 
Join Date: Jul 2013
Location: NS
Posts: 70
Likes: 0
Received 0 Likes on 0 Posts
Default

I said CRANK sensor not cam sensor. Crank sensor controls when your plugs ignite.
Old 08-01-13, 01:36 PM
  #6  
Flupmike22
Driver School Candidate
Thread Starter
 
Flupmike22's Avatar
 
Join Date: Jul 2013
Location: Nv
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by damiendada
I said CRANK sensor not cam sensor. Crank sensor controls when your plugs ignite.
I know your said "CRANK" sensor as I stated wouldnt the crank sensor just have the car fire like **** and it still would spark?
Old 08-01-13, 02:29 PM
  #7  
damiendada
Rookie
 
damiendada's Avatar
 
Join Date: Jul 2013
Location: NS
Posts: 70
Likes: 0
Received 0 Likes on 0 Posts
Default

If the crank sensor is gone it will not fire at all. If the cam sensor was bad it will run like ****. Doesn't hurt to test though. My car did same thing. I had fuel, compression, proper timing but my spark was not consistent. result was my car wouldn't start and I had wet plugs. I basically changed everything you said you did and still nothing. when I changed the crank sensor it rolled over right away. I say pull the wire on it and do a Ohms test just to be sure.
Old 08-01-13, 02:30 PM
  #8  
ThomasGS4
Lexus Test Driver
iTrader: (19)
 
ThomasGS4's Avatar
 
Join Date: Nov 2008
Location: TX
Posts: 9,491
Received 373 Likes on 218 Posts
Default

Originally Posted by Flupmike22
I know your said "CRANK" sensor as I stated wouldnt the crank sensor just have the car fire like **** and it still would spark?
I think you're thinking of the knock sensor.
Old 08-05-13, 12:18 PM
  #9  
Flupmike22
Driver School Candidate
Thread Starter
 
Flupmike22's Avatar
 
Join Date: Jul 2013
Location: Nv
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default

So i scanned the car no codes and live data showed up fine. I'm going to get my key reprogrammed. If that doesn't work in going to swap out the cps and if that doesn't work it's only gotta be one thing the ecu....
Old 08-22-13, 12:00 AM
  #10  
Jacob0015
Driver School Candidate
 
Jacob0015's Avatar
 
Join Date: May 2013
Location: CA
Posts: 30
Likes: 0
Received 0 Likes on 0 Posts
Default

I had this issue a while back. Turned out it was the key. If the key's not programmed to the car then it will crank but not start. Maybe the battery died on one of them? I'm not sure if a dead battery affects it, probably would though. I had 3 keys and 1 wasn't programmed so it would crank but the other 2 started it up just fine.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
2jznosht
SC- 1st Gen (1992-2000)
6
08-27-11 01:14 PM
luckyis300
IS - 1st Gen (2001-2005)
1
07-27-11 07:39 AM
jpaulmac
LS - 1st and 2nd Gen (1990-2000)
27
03-28-11 01:52 PM
youforia
LS - 1st and 2nd Gen (1990-2000)
8
02-07-06 11:46 AM
Yg_green1
GS - 1st Gen (1993-1997)
3
09-22-05 02:53 AM



Quick Reply: HELP!!! Gs won't start and has no spark!



All times are GMT -7. The time now is 06:14 AM.