01 GS430 .. CEL/codes
#1
Driver School Candidate
Thread Starter
Join Date: Jun 2007
Location: Florida
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
01 GS430 .. CEL/codes
ran to autozone to pull/reset codes, which are below - car has 74k, o2 setup seems straight forward (anyone chime in on part #?) - what steps do you guys recommend taking to fix codes 40-46?
thanks.
P0135 - o2 sensor/heater/malfunct bank 1-sensor1
P0440 - evap emission system/malfunction
P0441 - evap system purge flow fault
P0446 - emission control system vent circuit malfunc
thanks.
P0135 - o2 sensor/heater/malfunct bank 1-sensor1
P0440 - evap emission system/malfunction
P0441 - evap system purge flow fault
P0446 - emission control system vent circuit malfunc
#2
Rookie
iTrader: (15)
Take off the engine's valve cover and look at the resonator box on the passenger side of the engine. The box should have hoses connecting to the air intake pipe.
Looking at the box, check that all the hose attached to it are intact and are not leaking. Usually when you get those 3 codes, one of the hose is disconnected.
Looking at the box, check that all the hose attached to it are intact and are not leaking. Usually when you get those 3 codes, one of the hose is disconnected.
#3
Driver School Candidate
Thread Starter
Join Date: Jun 2007
Location: Florida
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
thanks, i'll look into it and report back. fuel gauge is also off (does not read accurately below 1/2 tank, often drops below E), any ideas?
thanks
thanks
#5
Lexus Champion
iTrader: (10)
bringing this one back up.
I got the p0135 code and this time it's the heater circuit issue. it's a brand new o2 sensor, I took the old one off thinking that the heater element went bad. The new one gave the same code.
Is there a fuse for these heater element?
I replaced the o2 sensor on the exhaust manifold..right before the cat, on the 2001 gs430. bank1 sensor 1. Passenger exhaust manifold, right???
I'm getting conflicting information on this, someone said the v8, it would be on driver side exhaust manifold and passenger side for the inline 6.
I got the p0135 code and this time it's the heater circuit issue. it's a brand new o2 sensor, I took the old one off thinking that the heater element went bad. The new one gave the same code.
Is there a fuse for these heater element?
I replaced the o2 sensor on the exhaust manifold..right before the cat, on the 2001 gs430. bank1 sensor 1. Passenger exhaust manifold, right???
I'm getting conflicting information on this, someone said the v8, it would be on driver side exhaust manifold and passenger side for the inline 6.
Last edited by sam430; 07-24-10 at 02:42 PM.
Thread
Thread Starter
Forum
Replies
Last Post
stasek
LS - 4th Gen (2007-2017)
9
02-02-18 08:50 AM