New to Forum - Check Engine/Check VSC After Weapon-R Intake Installation - HELP!
#17
Intermediate
iTrader: (8)
First off other member have already established that YOU DONT NEED TO REPLACE ANY O2 SENSORS. Why would you purchase them? The issue is only with the maf sensor. Did you even attempt to try the solutions from weapon-r that are posted?
Finally, this isnt even the SC forum.
If you want to troubleshoot a problem it is a good idea to actually completely reading the first page.
Finally, this isnt even the SC forum.
If you want to troubleshoot a problem it is a good idea to actually completely reading the first page.
I just got this response from Weapon-R:
You can try a couple things. The Toyota/lexus are sometimes touchy.
#1 Clean the MAF sensor with some electrical contact cleaner spray. Let it fully dry.
#2 check that the O ring on the MAF is tight when inserted into the pipe.
#3 Try to pull the rubber coupler farher away from the end. So maybe the filter isn’t too close to the MAF.
We have a 2008 Rav4 that our accountant drives and actually had the same thing happen. We did the steps above and its been clear for a while
Chris Wanstrath
Weapon-R Sales Manager
180 Sylvester Rd.
South San Francisco CA, 94080
Tel: 650-877-8280 Fax: 650-877-8290
AIM: Weaponrcs
You can try a couple things. The Toyota/lexus are sometimes touchy.
#1 Clean the MAF sensor with some electrical contact cleaner spray. Let it fully dry.
#2 check that the O ring on the MAF is tight when inserted into the pipe.
#3 Try to pull the rubber coupler farher away from the end. So maybe the filter isn’t too close to the MAF.
We have a 2008 Rav4 that our accountant drives and actually had the same thing happen. We did the steps above and its been clear for a while
Chris Wanstrath
Weapon-R Sales Manager
180 Sylvester Rd.
South San Francisco CA, 94080
Tel: 650-877-8280 Fax: 650-877-8290
AIM: Weaponrcs
Last edited by xanderES; 10-29-14 at 11:13 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Jbakyy
IS - 2nd Gen (2006-2013)
9
06-02-22 06:59 PM