Door lock mechanism fell into door
#1
Driver School Candidate
Thread Starter
Join Date: Feb 2013
Location: OR
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Door lock mechanism fell into door
Hey all.
The locking mechanism on our 96 ES300 fell into the door chamber. I recently fixed the small plastic piece that hold the rod into place but apparently I didn't fasten it well enough and after a few months the whole thing just sort of fell in.
Well now I can't open the door from inside or out. I think I can fix it if I can get the panel off but how does one go about doing that if it won't open from inside or out.
Surely someone has had to do this before. Any help appreciated. Hoping to get it done tomorrow.
thanks!
The locking mechanism on our 96 ES300 fell into the door chamber. I recently fixed the small plastic piece that hold the rod into place but apparently I didn't fasten it well enough and after a few months the whole thing just sort of fell in.
Well now I can't open the door from inside or out. I think I can fix it if I can get the panel off but how does one go about doing that if it won't open from inside or out.
Surely someone has had to do this before. Any help appreciated. Hoping to get it done tomorrow.
thanks!
Thread
Thread Starter
Forum
Replies
Last Post
gulleyman
GS - 1st Gen (1993-1997)
15
09-19-21 08:05 PM
Lubeboy
SC- 1st Gen (1992-2000)
5
05-30-17 12:52 AM
tonyzebra
ES - 1st to 4th Gen (1990-2006)
15
08-22-12 04:40 PM