Zelfiris' ISF
#35
Lead Lap
Thread Starter
#37
Lead Lap
Thread Starter
Yes that's right and I don't see the tape or anything
If you plan on debadging your ISF, just a head's up - On the trunk is a hole on the L letter (L E X U S)
If you plan on debadging your ISF, just a head's up - On the trunk is a hole on the L letter (L E X U S)
#39
Lead Lap
Thread Starter
Also, just my opinion. Its a lot more cost effective to paint yourself. My body shop did a great job but I see chipping around the edges for the lettering and honestly, if I had done it myself, I just need to respray down the road.
https://www.clublexus.com/forums/aut...e-emblems.html
#40
Driver School Candidate
Just resurrecting this relic thread since I believe Zelfiris has moved on, and I am the new owner. Shot them a P.M. to try to confirm, but last activity was 2 months before I even test drove it from a dealer.
The Vinyl is gone, and the rep spoiler was trashed during removal (along with some minor chips/dings to the trunk lid in that area. The gloss black name badges were also trashed, finally replaced them, but had to get generic 'chrome' ones, scratch em up, and plastidip. It turned out better than I was expecting. Finally figured out how to get hardware safely lodged into the ABS base plate of the replacement lip spoiler, but the weather cooled off too much to trust proper adhesion, fortunately a heat wave is en route. Unfortunately I am working pretty much all the way through, hopefully have enough time, but I doubt I'll revisit until next weekend.
Took apart the intake to clean the cone filter, MAF, intake pipe and throttle body today, and haven't been able to get thoughts of the VLand update tail lights out of my head. Would need to be smoked to align with the gloss black/carbon theme. Will get pictures sometime, haven't bothered with picture uploading in ages, so will have to familiarize myself all over again.
The Vinyl is gone, and the rep spoiler was trashed during removal (along with some minor chips/dings to the trunk lid in that area. The gloss black name badges were also trashed, finally replaced them, but had to get generic 'chrome' ones, scratch em up, and plastidip. It turned out better than I was expecting. Finally figured out how to get hardware safely lodged into the ABS base plate of the replacement lip spoiler, but the weather cooled off too much to trust proper adhesion, fortunately a heat wave is en route. Unfortunately I am working pretty much all the way through, hopefully have enough time, but I doubt I'll revisit until next weekend.
Took apart the intake to clean the cone filter, MAF, intake pipe and throttle body today, and haven't been able to get thoughts of the VLand update tail lights out of my head. Would need to be smoked to align with the gloss black/carbon theme. Will get pictures sometime, haven't bothered with picture uploading in ages, so will have to familiarize myself all over again.
Thread
Thread Starter
Forum
Replies
Last Post
ngl1145
IS F (2008-2014)
26
04-29-08 04:42 PM