1998 GS3 2jzgte swap won't idle with MAF
#1
Driver School Candidate
Thread Starter
1998 GS3 2jzgte swap won't idle with MAF
Hey guys I have been searching all over this site and other forums with no luck. So I recently finished my 2jzgte vvti swap into my 98 gs300. The problem I am having is it will idle fine without the MAF plugged in but as soon as I plug it in the car sputters and dies within 3 seconds. I have tested the MAF and it is within spec and responds to air. I even tried a new MAF with the same results and I am using the correct GTE sensor in a 3" intake pipe. I have reset the ecu, checked resistance on all sensors on the TB, all are in spec but still no luck. Any ideas?
Last edited by KawiKid10R; 07-21-14 at 08:33 PM. Reason: change title
#3
Driver School Candidate
Thread Starter
It just doesn't get above 20mph can't press the peddle too much it'll sputter and die. I've also checked the intake manifold and vacuum lines for any leaks. I'm think the ecu could be bad. That's my last guess otherwise I'm stumped.
Thread
Thread Starter
Forum
Replies
Last Post