ClubLexus - Lexus Forum Discussion
Amazon purchase.... blue is way easier to find
Amazon purchase.... blue is way easier to find
0 2019/12/14 17:33:30
Silicone covers fit nice and snug
Silicone covers fit nice and snug
0 2019/12/14 17:31:34
First attempt at searching for this part by itself
First attempt at searching for this part by itself
0 2018/09/23 21:53:53
Reason why this thread was started Thanks for the suggestions fellas (Just sharing what i had to do for reference incase somone Else encounters a seized pin)
Reason why this thread was started Thanks for the suggestions fellas (Just sharing what i had to do for reference incase somone Else encounters a seized pin)
0 2018/09/23 19:20:08
Root reason why this thread was started. Thanks for the suggestions fellas.. (Hope you guys dont have to do what i did.. just sharing If anyone else encounters the same seized piece) These will be the quickest and easiest pads to access. Crazy simple design
Root reason why this thread was started. Thanks for the suggestions fellas.. (Hope you guys dont have to do what i did.. just sharing If anyone else encounters the same seized piece) These will be the quickest and easiest pads to access. Crazy simple design
0 2018/09/23 19:05:31
There is the lexus part number. Comes with upper and lower pin, middle pin and 13mm bolt (with thread lock already on the thread and the retaining bracket. Also picked up 4 new wheel nuts. HATE lock nuts
There is the lexus part number. Comes with upper and lower pin, middle pin and 13mm bolt (with thread lock already on the thread and the retaining bracket. Also picked up 4 new wheel nuts. HATE lock nuts
0 2018/09/23 18:55:03
Tomorrow Picking up a tube brush to clean out the bore for the middle pin. New one goes in tight.. too tight Might sand down the pin a smidge too.
Tomorrow Picking up a tube brush to clean out the bore for the middle pin. New one goes in tight.. too tight Might sand down the pin a smidge too.
0 2018/09/23 18:47:22
New pin/13mm bolt on top * going to source that middle pin/bolt (Unless anyone knows a brembo or aftermarket part number)
New pin/13mm bolt on top * going to source that middle pin/bolt (Unless anyone knows a brembo or aftermarket part number)
0 2018/09/23 18:41:30
Second cut. Used BFH and inner came out. Used 1/4 punch and BFH to push the outer part out. (Man... it was in there good!!)
Second cut. Used BFH and inner came out. Used 1/4 punch and BFH to push the outer part out. (Man... it was in there good!!)
0 2018/09/23 18:36:40
M8x1.25 longer bolt and BFH No dice. Got mad and used grinder
M8x1.25 longer bolt and BFH No dice. Got mad and used grinder
0 2018/09/23 18:33:15