ClubLexus - Lexus Forum Discussion
0 2018/02/11 15:33:22
0 2018/02/11 15:35:57
0 2018/02/11 15:36:41
Stay out of the deep end... Got it
Stay out of the deep end... Got it
0 2018/02/11 15:37:36
0 2018/02/11 15:42:38
0 2018/02/21 15:56:51
0 2018/02/28 17:01:38
0 2018/02/28 17:01:40
0 2018/03/05 17:00:50
0 2018/03/05 17:00:55
It came back.
It came back.
0 2018/03/07 15:32:21
I drilled holes and used wire to pull it in on 8/25/17
I drilled holes and used wire to pull it in on 8/25/17
0 2018/03/07 15:32:25
0 2018/03/07 15:32:28
0 2018/03/07 15:32:32
0 2018/03/07 15:32:53
0 2018/03/07 15:33:13
0 2018/03/07 15:33:26
This is today. All good so far.
This is today. All good so far.
0 2018/03/07 15:35:24
0 2018/03/21 18:31:09
0 2018/03/21 18:31:15
0 2018/03/22 15:51:59
0 2018/03/22 15:53:43
0 2018/03/22 16:04:38
0 2018/03/23 14:48:54
0 2018/03/23 16:32:28
0 2018/03/24 16:38:44
0 2018/03/31 16:20:52
0 2018/04/06 17:29:41
0 2018/04/07 15:35:22
0 2018/04/07 15:35:24
0 2018/04/07 15:35:30
Why the uneven bottom? Pics on Amazon look to the be the same.
Why the uneven bottom? Pics on Amazon look to the be the same.
0 2018/04/07 15:35:34
0 2018/04/07 15:35:47
0 2018/04/07 15:36:21
I kept grinding off plastic and got closer to a fit. No depth measurement specs on Amazon and it is a Little too deep so I cut the of the bottom.
I kept grinding off plastic and got closer to a fit. No depth measurement specs on Amazon and it is a Little too deep so I cut the of the bottom.
0 2018/04/07 15:36:24
0 2018/04/07 15:36:28
0 2018/04/07 15:36:34
0 2018/04/07 15:38:47
Got it flush enough to close the door but unable to install the tabs where the molded GX part is for OEM insert on the rear.
Got it flush enough to close the door but unable to install the tabs where the molded GX part is for OEM insert on the rear.
0 2018/04/07 15:41:11
0 2018/04/08 13:21:06