ClubLexus - Lexus Forum Discussion
Share Your Pictures with Our Community. Upload Now
0 2019/01/27 18:12:15
Easy access to the rear fasteners that holds down the intake surge tank. I now have much more confidence in a DIY job on the spark plug replacement. The driver side windshield wiper arm removal was a PITA. However, with easier access to the firewall and the fasteners to the intake and surge tank stays, this makes the job easier.
Easy access to the rear fasteners that holds down the intake surge tank. I now have much more confidence in a DIY job on the spark plug replacement. The driver side windshield wiper arm removal was a PITA. However, with easier access to the firewall and the fasteners to the intake and surge tank stays, this makes the job easier.
0 2019/01/27 17:43:08
Look Ma. No Tray! Lots of access. You can see the fire wall!
Look Ma. No Tray! Lots of access. You can see the fire wall!
0 2019/01/27 17:41:43
Bottom metal tray and the fastneners. There are six 10 mm bolts plus four 14 mm nuts. The 14 mm nuts are to your struts. You will find one 14 mm to each strut DOES NOT have to be removed and this holds the alignment. Before removing the two 14 mm nut, make sure this remaining nut is tight!
Bottom metal tray and the fastneners. There are six 10 mm bolts plus four 14 mm nuts. The 14 mm nuts are to your struts. You will find one 14 mm to each strut DOES NOT have to be removed and this holds the alignment. Before removing the two 14 mm nut, make sure this remaining nut is tight!
0 2019/01/27 17:37:35
Wiper Assembly removed with five 10 mm screws. Now you can remove the bottom metal tray. Once the wiper assembly is removed the fasteners to the bottom metal tray is obviousl.
Wiper Assembly removed with five 10 mm screws. Now you can remove the bottom metal tray. Once the wiper assembly is removed the fasteners to the bottom metal tray is obviousl.
0 2019/01/27 17:35:06
The electrical plug is tricky to remove because you have to depress under the plug to remove the electrical plug. Once the electrical plug is removed and removed from the bottom metal tray, there are 5 10 mm screws to unbolt the windshield wiper motor.
The electrical plug is tricky to remove because you have to depress under the plug to remove the electrical plug. Once the electrical plug is removed and removed from the bottom metal tray, there are 5 10 mm screws to unbolt the windshield wiper motor.
0 2019/01/27 17:32:27
This is how I cut the upper plastic top with a dremel to remove the upper plastic top to allow my windshield puller to remover the driver side windshield. The hole was much too small to allow my tool to pull the wiper off. With this cut, I removed the top cover and then use the tool to remove the wiper. The Lexus is 10 years old so it was not a big deal to me.
This is how I cut the upper plastic top with a dremel to remove the upper plastic top to allow my windshield puller to remover the driver side windshield. The hole was much too small to allow my tool to pull the wiper off. With this cut, I removed the top cover and then use the tool to remove the wiper. The Lexus is 10 years old so it was not a big deal to me.
0 2019/01/27 17:27:55
There are spring loaded tabs that attached the upper plastic cover to the bottom metal tray. Use your thumb or a screw driver to depress the tabs.
There are spring loaded tabs that attached the upper plastic cover to the bottom metal tray. Use your thumb or a screw driver to depress the tabs.
0 2019/01/27 17:26:26
Note the hook. You have to pull the weatherstripping to the side to unhook. Do not pull up because you will tear it up.
Note the hook. You have to pull the weatherstripping to the side to unhook. Do not pull up because you will tear it up.
0 2019/01/27 17:24:42
Weatherstripping to the top windshield cover is attached by hooks. Pull the weatherstripping to the side (Not up or else you will break the weatherstripping)
Weatherstripping to the top windshield cover is attached by hooks. Pull the weatherstripping to the side (Not up or else you will break the weatherstripping)
0 2019/01/27 17:22:36
The driver side was a PITA. Difficult to pull the wiper arm off. I had to cut the top plastic cover with a dremel tool.
The driver side was a PITA. Difficult to pull the wiper arm off. I had to cut the top plastic cover with a dremel tool.
0 2019/01/27 17:19:56
Note the blue masking tape to mark the position of the wiper to ease reinstallation. The puller on the passenger side was easy.
Note the blue masking tape to mark the position of the wiper to ease reinstallation. The puller on the passenger side was easy.
0 2019/01/27 17:18:04
Advertisement
0 2019/01/27 17:06:36
0 2019/01/27 17:06:27
0 2019/01/27 17:06:23
0 2019/01/27 16:53:06
0 2019/01/27 16:52:51
0 2019/01/27 16:52:51
0 2019/01/27 16:36:22
0 2019/01/27 16:36:21
0 2019/01/27 16:36:21
0 2019/01/27 16:35:15
0 2019/01/27 16:35:10
0 2019/01/27 16:35:10
0 2019/01/27 16:35:10
0 2019/01/27 16:34:05
0 2019/01/27 16:33:49
0 2019/01/27 16:33:37
0 2019/01/27 16:33:25
0 2019/01/27 16:32:59
0 2019/01/27 16:26:48
0 2019/01/27 16:26:48
Advertisement