I know I might get ripped a new one for this, but I've searched and found 2 'titles' on this subject. I've read that the stock offset is +50. I had +35 on the car before, but am looking into this great deal on some 18x9 and 10 with a +30...Think this'll fit? Thanks all.

 

i don't think they will fit, even if you shave the whole fender

 

ajs, keep in mind if these fit you will still be moving the center of gravity more than a half inch off center. This could cause rapid wear on your bearings, especially at sustained high speeds (highway). It will also change the geometry of the suspension, making the wheel track differently over bumps. I would try to stay as close to the stock 50 offset as possible. Just my .02

 

I had 18X8.5 and 9.5 with a 17 mm offset all the way around. 30 will fit fine.