Install TPMS on New wheels.. (PICS)
#1
Lexus Test Driver
Thread Starter
Install TPMS on New wheels.. (PICS)
1) Mark the spot where you'd like to open the hole to install the sensor. You want to find a spot with similar curvitures as the stock wheel for best fitment. We are essentially installing a secondary valvestem. (remember you need the entire stem adn sensor unit from factory wheel)
2) Start with a small bit and drill a pilot hole.
3) Use a larger bits to open the hole just enough for the sensor to go through. Or to make life easier, use a uni-bit. I forget the hole/bit size... sorry guys...
4) Attach sensor and stem...
5) Try to position the new stem opposite the "actual" stem for better balance. You won't have to utilise as many weight when balancing the wheel.
6) Here's a view of the sensor from the other side after the tires been mounted...
2) Start with a small bit and drill a pilot hole.
3) Use a larger bits to open the hole just enough for the sensor to go through. Or to make life easier, use a uni-bit. I forget the hole/bit size... sorry guys...
4) Attach sensor and stem...
5) Try to position the new stem opposite the "actual" stem for better balance. You won't have to utilise as many weight when balancing the wheel.
6) Here's a view of the sensor from the other side after the tires been mounted...
#3
Advanced
Originally Posted by teejnut
That's a pretty good idea! Scary drilling into new rims though... where'd you get it done at?
I agree, I'll be scared to have someone drill into my wheels to attached the TPMS system, there must be another way.
Thread
Thread Starter
Forum
Replies
Last Post
GQis350
IS - 2nd Gen (2006-2013)
4
08-26-12 08:35 PM