Opinions of this brake setup
#1
Racer
Thread Starter
iTrader: (1)
Join Date: Feb 2003
Location: Massachusetts
Posts: 1,275
Likes: 0
Received 0 Likes
on
0 Posts
Opinions of this brake setup
Im going to need to replace my pads and rotors in an estimated 15,000 miles.
Im thinking of staying basically stock.
However, i'm thinking of putting on zeckhausen stainless steel lines for all 4 corners, and brembo basic non-drilled, non-slotted rotors for all corners. OEM toyota pads on all 4 corners.
Does this setup sound good? Are the basic brembo rotors as good as the toyota rotors? The ones on the car now are 12 years old and have 72K miles on them. The brembos are actually cheaper (60-70 each)
Perhaps in a few years if i really want to be bothered and I have a 98+ SC4, I would get forged 17" wheels so I could get a bigger brake setup, like from a 93 LS or the supra job, but it's unlikely.
Im thinking of staying basically stock.
However, i'm thinking of putting on zeckhausen stainless steel lines for all 4 corners, and brembo basic non-drilled, non-slotted rotors for all corners. OEM toyota pads on all 4 corners.
Does this setup sound good? Are the basic brembo rotors as good as the toyota rotors? The ones on the car now are 12 years old and have 72K miles on them. The brembos are actually cheaper (60-70 each)
Perhaps in a few years if i really want to be bothered and I have a 98+ SC4, I would get forged 17" wheels so I could get a bigger brake setup, like from a 93 LS or the supra job, but it's unlikely.
Thread
Thread Starter
Forum
Replies
Last Post