Is my Whiteline sway bar upside down?
#1
Rookie
Thread Starter
Is my Whiteline sway bar upside down?
92 SC400.
Rear Sway Bar, Whiteline
According to Whiteline I put my sway bar in upside-down. I tried the other way but can't get it to fit into place. This doesn't seem correct either because the middle part of the sway bar is angling down and I had always thought they were normally parallel to the ground.
Right rear from just behind the Rt. Rear tire
Rear Sway Bar, Whiteline
According to Whiteline I put my sway bar in upside-down. I tried the other way but can't get it to fit into place. This doesn't seem correct either because the middle part of the sway bar is angling down and I had always thought they were normally parallel to the ground.
Right rear from just behind the Rt. Rear tire
#2
Advanced
iTrader: (3)
92 SC400.
Rear Sway Bar, Whiteline
According to Whiteline I put my sway bar in upside-down. I tried the other way but can't get it to fit into place. This doesn't seem correct either because the middle part of the sway bar is angling down and I had always thought they were normally parallel to the ground.
Right rear from just behind the Rt. Rear tire
Rear Sway Bar, Whiteline
According to Whiteline I put my sway bar in upside-down. I tried the other way but can't get it to fit into place. This doesn't seem correct either because the middle part of the sway bar is angling down and I had always thought they were normally parallel to the ground.
Right rear from just behind the Rt. Rear tire
The following users liked this post:
GrantReid (06-14-18)
#3
Rookie
Thread Starter
Thank you so much. I must have emailed back and forth with Whiteline 4 times now without a yes/no answer. I made the mistake of removing the OEM swaybar without looking at how it was connected.
That's all I needed to know!
That's all I needed to know!
The following users liked this post:
GrantReid (06-14-18)
#5
Rookie
Thread Starter
Yours looks the same as mine shajbot. I will be leaving it as is then. I suppose not everyone at Whiteline knows the details on their products. It's too bad they don't just admit it.
Thread
Thread Starter
Forum
Replies
Last Post