Camber on stock 92 SC300 bolts?
#1
Driver School Candidate
Thread Starter
Join Date: Jul 2017
Location: Washington
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Camber on stock 92 SC300 bolts?
Im wondering what is the max ammount of negative camber i can run on the stock camber bolts? also, what would i need to do to go more negative? do i need to upgrade my knuckles or LCAs? or both?
TIA x
TIA x
#2
Instructor
iTrader: (2)
From what I have seen you can get around 2 degrees maybe a few tenths over without any modifications. The bolts will only rotate to about 45 degrees before running out of slot. If you slot the subframe so that the bolts are able to rotate to horizontal you can get 3. Daizen used to make an offset bushing kit for the upper control arm that would get you 4 or more, but I haven't been able to find it anywhere so I had to buy a set used. That's a shame because it works really well.
#3
Lead Lap
iTrader: (8)
Depending on how low you are determines how much negative camber you can get. I was able to get -1.9 in the front and -3 in the rear before. You would need adjustable UCA in the front. The megan arms can get you to - 8 or -9 degrees in the front. In the rear you can you'd need adjustable LCA and possibly UCA depending on how crazy you want to get.
I'm not a huge fan of the design of the megan arms. Personally, I would go with figs engineering.
I'm not a huge fan of the design of the megan arms. Personally, I would go with figs engineering.
Thread
Thread Starter
Forum
Replies
Last Post
mk4r34
Suspension and Brakes
3
02-20-12 12:24 PM