When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I read conflicting reports about about fitment and so I ordered one and was willing to cut and weld until I got it to fit however it fit right on without any modifications!
Are you even supposed to leave the brace on? It's the one that holds the struts atop right? Anyways, yeah, if it fits then I'm getting it, then get it polished, then get spdracr's rear STB with it since I now have sway bars. Perfect.
It should fit if you leave the brace that's on top of the struts, same goes to the 2jzge .
Looks very nice on your car, That's my favorite STB!
Yup it will fit if you take off the rings but the clearance between the emblem and the stb is not very much and the soft rubber engine mounts will allow too much flex and it will make contact so I just left them on for the time being as I plan on dropping in this gte hopefully over the winter months...Hopefully
So far I have only tested it in one high speed corner going to the turnpike on ramp and although I did not expect to feel any difference I did so I turned around and re ran the corner at even higher speed and there is 100% without a doubt a big difference from the stb that was on the car when I got it to the TRD unit.
If anybody is thinking of getting one pull the trigger now as TRD prices have gone up almost 40%
Thank you!^^ Elmhurst got it to me for about 190 shipped all the rest wanted like 25 for shipping which is why I went with them plus Curt has done all my Toyota oem parts needs with speed and grace lol
That bar sure looks nice and actually does something unlike others. I had one of these on my sc but took it off since it didn't work for me. Good looking rsp you have there.