biggregg24

Block decked and cleaned up

Cleaned up and undercoated the whole car before lines
Rear sub pre cleaned
Then rear sub after blasting

2KHarrier

Nice progress. It helps to have access to tooling through work. When I redid my wheels a few years ago, I used the media blaster at work, and the paint booth. Makes all the difference.

biggregg24

Got the sub coated
Same with diff
Ooo new clevites
Je 9.5:1 forged pistons
After about 4 hours, everything lubed and torqued

Aron9000

What else are you doing with the engine rebuild??? What sort of rods, rod bolts, and crank are you running? What sort of head gasket? I know if you go NA-T and keep the bottom end stock(ie stock pistions, which you didn't use) you need a thicker headgasket to lower the compression ratio a bit.

biggregg24

stock rods and rod bolts, everything else is arp studs, I am putting a cometic 1.3 gasket on, but I had .015 decked off block, so I should be right around 10:1 which will be perfect for 20 psi or so on e85

biggregg24

Head cleaned up good!
Oooo studs!



Manifold, turbo and dp fitted
New peices!
1k Bosch injectors
Modded fuel rail fitted
All buttoned up ready to drop in

BlueJ

Can not wait to see that Nissan Trans go in at this rate of progress

evltwn

Awesome build. What do you have planned for the interior?

biggregg24

Going in
Got a helper
He already knows whats up
Sitting pretty

Modded fuel top
Walbro 450 installed

Seize

Looks like it's coming along quite nicely

g4ebguy90

I don't know how you guys find these deals.

biggregg24

maybe racing seats and a new Carpetfor now, that'll be last on the lost after exterior probably

biggregg24

Rear sub is getting closer to going in!

97-SC300

iTrader: (17)

I like seeing progress like this. Not wasting time or beating around the bush! Very nice work Sir.

biggregg24

thanks man, considering I've read through your entire thread, your car is beautiful!