Aluminum shifter paddles from the RC-F.
These were a direct swap. HUGE improvement in look and feel over the stock plastic ones. They are also a bit larger horizontally.

 

What do they go for?

 

Installation guide?

 

They were about 170 for the pair.

Install is very simple. Once you remove the steering wheel they are just screwed on to the back, 2 screws and one small harness on each. The entire install took less than 30 minutes, including a short drive to make sure I put my steering wheel back on strait because I forgot to mark the spines lol 😧

 

googled the part numbers, looks like they're around $100 usd each.

 

$191.90 including shipping. Just shop around a bit

 

how does the steering wheel airbag come out?

 

Cool mod but it looks the same. and really i never use them. i'll just ride out my lease and save the $170 lol

 

i’ve wanted to do this for so long! thank god i found the part # for it

 

does anybody know the part # for the shifter boot and shift **** for the RCF/GSF?

 

The Parts Specialists have them for $88.42 Each

https://www.thepartsspecialist.com/o...tch-8461024020

https://www.thepartsspecialist.com/o...tch-8461024010

 

this one looks like the RCF **** but has "f sport" on it. not oem, but looks pretty hot!

http://www.bulletproofautomotive.com...ent-shift-****

 

Same. If I wasn't leasing I would consider this mod, as they do look a bit better than the stock ones - in the stock paddles, you can see the silver metallic paint is, well, paint-like in appearance, where the RC F paddles look smooth and uniform, with no flakes. Very nice!

 

I believe the shift **** for the RCF is Part #33504-24150-C3 and the boot is 58808-24050-C7.

 

Subtle but it looks really good! I haven't personally seen the RC-F paddle shifters. Are they made of aluminum?