When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm asking $250 for the grille. It is like new has been repainted in glossy black and the metal mesh has been replaced with new mesh and painted black also. Let me know if you're interested.
I'm asking $250 for the grille. It is like new has been repainted in glossy black and the metal mesh has been replaced with new mesh and painted black also. Let me know if you're interested.
Hey Shawn,, had a question about ur wind deflector. Did u run a wire to the front to control the led strip on it or is there a button on the strip u press to turn it off and on?
Hey Shawn,, had a question about ur wind deflector. Did u run a wire to the front to control the led strip on it or is there a button on the strip u press to turn it off and on?
I wired 12v through the trunk via the firewall grommet, off a 12v wire off my NavIKS install. There is a small rocker switch just under the rear seat to allow me to toggle it on/off.
I wired 12v through the trunk via the firewall grommet, off a 12v wire off my NavIKS install. There is a small rocker switch just under the rear seat to allow me to toggle it on/off.
Ok nice. Was thinking about jus tapping the rear light so when my lights turn on so does the led.
I wired 12v through the trunk via the firewall grommet, off a 12v wire off my NavIKS install. There is a small rocker switch just under the rear seat to allow me to toggle it on/off.
Did u trim the bottom of the plexiglass or cut into the deck under it to put the led strip? There ls like no room under it to fit the strip I have.
no. Mine fit fine, wedged under it. Had to use some pressure but once deflector bolts were tightened, no problem.
Oh ok nice. So the deflector is pressing down on the strip a bit. I def didn't want to cut the deck and I didn't want to cut the deflector either bc it may take the wind deflection away from having the gap underneath. I'm thinking about putting it in a channel of some sort to hide the diodes so only the light will show but we'll see how that pans out with the limited clearance.