Help with Power Steering Pump
Thread Starter
Driver School Candidate
Joined: Aug 2014
Posts: 1
Likes: 0
From: AL
Help with Power Steering Pump
I'm replacing the PS Pump on my 95 SC400 and while I was removing everything I got 3 of the bolts out but the top rear bolt is starting to strip and it's super tight. Any ideas on how to go at this thing before I completely destroy the bolt?
Driver School Candidate
Joined: Aug 2014
Posts: 8
Likes: 0
From: Florida
I removed top first so weight was not held by that bolt.
Opposite problem....same car....
Unit and reservoir out, but high pressure line remains attached. Can't break either at bottom cross member
or the 22mm nut on the unit. Suggestions?????
Opposite problem....same car....
Unit and reservoir out, but high pressure line remains attached. Can't break either at bottom cross member
or the 22mm nut on the unit. Suggestions?????
Thread
Thread Starter
Forum
Replies
Last Post
rome99LS
LS - 1st and 2nd Gen (1990-2000)
11
Jan 20, 2012 02:08 PM