i just debaged my SC recently and for now taped the holes up. i was thinking to fiberglass the back of the bumper and put bondo on the outside and then sand. wat have u guys done to debadge your cars?

 

Bondo or weld the holes and never have to worry about cracking.

 

fiberglass should be good on the bumper.....I would fiberglass the back and then fill the holes on front side up with the resin.....

As for the trunk it would be best to have them welded.....Bondo may hold up for awhile but hard to tell

 

If you don,t weld the holes shut in the sheet metal , you must dent the hole area deep enough to get a sufficient layer of tiger hair on for reinforcement, then bondo, or the holes will just pop back out in time. If you have access to a plastic welder that would be best for the bumper.

 

so i'll fiberglass the bumper and bondo it. and the trunk i'm not sure yet. idk where i can get it welded, maybe my buddy knows how to weld. maybe i'll get an autobot emblem off ebay lol. thanks for the advice guys.