Turbo coolant fitting blew
Thread Starter
Driver School Candidate
Joined: Aug 2012
Posts: 48
Likes: 0
From: bc
Turbo coolant fitting blew
Hellur,
I was wondering if anyone could help me with this question. I just redid my turbo lines and i had to put a 90 degree bend in one and than put a bigger hose over it to my turbo fitting. I was revving my car to make sure the one fitting wasnt leaking and on the other side started squirting coolant. I am obviously going to replace the line but i was wondering could that have happened bcuz there it too much pressure built up where i have the bigger hose reduce to the smaller or could it be that the line was just weak. or could both be a cause. I also notice a kink in the line that burst. It is a braided steel line.
thanks in advance
I was wondering if anyone could help me with this question. I just redid my turbo lines and i had to put a 90 degree bend in one and than put a bigger hose over it to my turbo fitting. I was revving my car to make sure the one fitting wasnt leaking and on the other side started squirting coolant. I am obviously going to replace the line but i was wondering could that have happened bcuz there it too much pressure built up where i have the bigger hose reduce to the smaller or could it be that the line was just weak. or could both be a cause. I also notice a kink in the line that burst. It is a braided steel line.
thanks in advance
Thread
Thread Starter
Forum
Replies
Last Post
zneubauer
SC - 1st Gen (1992-2000)
1
Aug 8, 2017 11:17 AM
