Notices
SC - 1st Gen (1992-2000)

car jerks forward and backward when driving

Thread Tools
 
Search this Thread
 
Old Dec 4, 2012 | 09:11 PM
  #31  
scott101's Avatar
scott101
Thread Starter
Pole Position
 
Joined: Feb 2012
Posts: 272
Likes: 0
From: nor cal
Default

well, im back, unfortunately

what are the odds the maf I just put in went bad? it was used from the yard, but it seems fishy

I drove the car every day for about 10 days or so. then I took out the old drivers seat to put in my bucket seat. i welded the little tabs to the sliders in the car, finished the welds outside the car, and not I have a bucket seat

then I plugged the battery back in and it ran fine

but once it warmed up, same symptoms as before. jerking at 2500 rpms under acceleration and when in neutral, it occasional sounded like the motor was stumbling/hestitating. the rpms would drop about 200 and then recover over and over (this happened a couple times)

ill go try another maf, then repost my results here

thanks for all of the help you guys, I really appreciate it
-scott
Reply
Old Dec 4, 2012 | 09:43 PM
  #32  
OG Dada's Avatar
OG Dada
Lexus Champion
iTrader: (10)
 
Joined: Apr 2011
Posts: 3,118
Likes: 17
From: CA
Default

Here's how to test the MAF.



Didn't really wanna read everything, but have you set the TPS to spec? Next thing I would check would be the distributor, something to deal with ignition, like wires, spark plugs, coil packs and/or fuel injectors...

Last edited by OG Dada; Dec 4, 2012 at 09:49 PM.
Reply
Old Dec 5, 2012 | 07:18 AM
  #33  
SC400slide's Avatar
SC400slide
In Recovery Mode
CL Folding 25,000
iTrader: (11)
 
Joined: Apr 2012
Posts: 3,871
Likes: 36
From: NM
Default

Before replacing it again, I would definitely check the MAF using the ohmmeter just to make sure. Could even be your TPS again lol...

Last edited by SC400slide; Dec 5, 2012 at 07:19 AM. Reason: grammar and such
Reply
Old Dec 6, 2012 | 10:24 PM
  #34  
scott101's Avatar
scott101
Thread Starter
Pole Position
 
Joined: Feb 2012
Posts: 272
Likes: 0
From: nor cal
Default

ok, thanks, will do. doesnt help that my car wont even start now, starter motor spins but no spark I guess, Ill check that first, then see where Im at

thanks again for all the help, I appreciate it a ton, Ill report back where Im at after tomorrow
-scott
Reply
Old Dec 7, 2012 | 07:39 AM
  #35  
SC400slide's Avatar
SC400slide
In Recovery Mode
CL Folding 25,000
iTrader: (11)
 
Joined: Apr 2012
Posts: 3,871
Likes: 36
From: NM
Default

So what it could be: Un-calibrated TPS, Fuel pump ECU, ECU, Fuel pump, MAF...????
Is there any CEL? If there is pull the codes to see what comes up.
Read through these threads. Don't start just replacing thing's you don't need to though.
https://www.clublexus.com/forums/sc-...en-dies-2.html
https://www.clublexus.com/forums/per...on-issues.html
Reply
Old Dec 7, 2012 | 09:21 AM
  #36  
scott101's Avatar
scott101
Thread Starter
Pole Position
 
Joined: Feb 2012
Posts: 272
Likes: 0
From: nor cal
Default

Originally Posted by SC400slide
So what it could be: Un-calibrated TPS, Fuel pump ECU, ECU, Fuel pump, MAF...????
Is there any CEL? If there is pull the codes to see what comes up.
Read through these threads. Don't start just replacing thing's you don't need to though.
https://www.clublexus.com/forums/sc-...en-dies-2.html
https://www.clublexus.com/forums/per...on-issues.html
alright, thanks. no check engine light that I noticed, I will double check today and try testing a few different things with the multimeter i have. hopefully Ill find something

could the maf or tps alone prevent it from starting? or would those just cause bad running once it is running

not starting seems to me like it would me more like ignition coil or something like that

-scott
Reply
Old Dec 7, 2012 | 09:32 AM
  #37  
SC400slide's Avatar
SC400slide
In Recovery Mode
CL Folding 25,000
iTrader: (11)
 
Joined: Apr 2012
Posts: 3,871
Likes: 36
From: NM
Default

Here is another thread to check out. https://www.clublexus.com/forums/per...-starting.html
Could be ignition coil as well.
Just test the MAF and see if it broke already. We'll go from there.
Reply
Old Dec 8, 2012 | 10:27 PM
  #38  
scott101's Avatar
scott101
Thread Starter
Pole Position
 
Joined: Feb 2012
Posts: 272
Likes: 0
From: nor cal
Default

i put in a different tps (I have a collection of them now) and adjusted it all the way counterclockwise, however, Im not sure if it is in the right way/adjusted properly, because anything other than maxed out counterclockwise and it doesnt run well, and too far clockwise the car will shut off. it ran fine tonight though

-scott
Reply
Old Dec 8, 2012 | 11:52 PM
  #39  
iridebmx's Avatar
iridebmx
Lexus Test Driver
iTrader: (6)
 
Joined: May 2010
Posts: 1,442
Likes: 4
From: Colorado Springs, CO
Default

crank angle/position sensor is another cheap part that i would replace, it can possibly be a reason for all the above problems
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
skyther
LS - 1st and 2nd Gen (1990-2000)
2
Oct 20, 2017 06:09 PM
faithmkss
ES - 1st to 6th Gen (1990-2018)
6
Oct 19, 2015 04:04 PM
Polo708
GS - 4th Gen (2013-2020)
11
Mar 2, 2015 07:23 PM
Todd1225
SC - 1st Gen (1992-2000)
16
Aug 15, 2009 09:12 PM
Todd1225
SC - 1st Gen (1992-2000)
1
Apr 13, 2007 10:59 AM




All times are GMT -7. The time now is 01:06 PM.