hey everyone, i'm doing a mk3 w58 conversion into my sc400.

I'm wondering if anyone knows how long the stock sc300 w58 driveshaft is, i can find out once the transmission is in, but i'm wanting to get the shaft made before hand so i can just put it together and drive it home.

So i guess i need to know how long the front half of the shaft is from the tip of the yoke to the flange that mounts to the rear half of the 2 peice driveshaft.

please let me know, thanks!

 

nobody? Need the info so i can get the shaft made, thanks!

 

From the tip of the yoke to the back of the mounting flange to the rear 24 3/4"
Off a 92 SC300 5 speed

 

You rock man! thanks so much!

I wonder if this is the same part as the mk3 shaft? looks the same.

how long is the snout on the yoke? if its the same then i should be good to go!

 

Snout 3&7/8.