Getting Ready to lower and have a question
Hey guys I got my wheel's on and they looked great! They are g35 "replica" wheels black w/a polished lip. I'm running a 245/40/18 tire all the way around offset is + 38, and lowering Thursday on Supra KYB AGX shocks and Tanabe GF210 Lowering Springs. A couple a questions I have is
1. Will I really need to relocate the wiring harness in the driver's side fender? I've read most post saying ppl w/coilovers only need too.
2. Will I need to roll my fenders at all? The drop is suppose to be 2" when settled and it really look's like its gunna rub too me. I know the lowest offset you can go is a 38 which i'm at right now i've read in the wheel fitment guy I should be ok but just want some opinions.
Any feedback would be greatly appreciated!
Thanks
-Nick
1. Will I really need to relocate the wiring harness in the driver's side fender? I've read most post saying ppl w/coilovers only need too.
2. Will I need to roll my fenders at all? The drop is suppose to be 2" when settled and it really look's like its gunna rub too me. I know the lowest offset you can go is a 38 which i'm at right now i've read in the wheel fitment guy I should be ok but just want some opinions.
Any feedback would be greatly appreciated!
Thanks
-Nick
1) Yes, I recommend it on any drop. Your car will thank you later...you may not rub at stop or even during minor compression strokes but a big dip or bump could potentially rub it raw. It doesn't take much...
2) I can't comment on, if it looks like it's going to rub more than likely it will.
2) I can't comment on, if it looks like it's going to rub more than likely it will.
Thread
Thread Starter
Forum
Replies
Last Post
mhenrey
SC - 1st Gen (1992-2000)
7
Apr 16, 2008 08:04 PM




