I need a simple diagram showing the location and pinouts for the body harness for a 92-94 sc300 (unless all years are the same, even one for a 400 will work). I have searched and searched, but can only find a couple that seem to NOT match up properly...

I need the pinouts for the tach signal, speedometer signal and a few others coming from the ecu. I have the ecu pinout, but its vague at best...

 

http://www.supras.nl/index.php?optio...d=34&Itemid=50


Check out the lower 2JZGTE section... they are very similar to the 2JZGE body wise. Best I can do online bro. I only have printed schematics for MK4 Supra.

 

Thanks Diddy, that should work perfectly.

 

Good Luck, I am about to start my 1UZ rebuild as well. When you said 5.7, I thought you meant 2009 5.7L Tundra motor.

 

Thanks again. And you werent the only one that thought I went with the Tundra swap, but I needed an engine with solid aftermarket support