What did you do to your SC today?
The following users liked this post:
Dabiskit (02-21-18)
The following users liked this post:
jadu (03-05-18)
#7162
Lead Lap
iTrader: (8)
The following users liked this post:
jadu (03-05-18)
#7165
Pole Position
#7168
Driver School Candidate
iTrader: (1)
Little bigger than factory SC rotor and now ISF rotor!!
Got Brembo!!
Brackets from Pkop front and rears. Makes this a simple install.
One side on to the next one!!
Complete and brake pads bedded in. Pad grabs whole machined area of the rotors. Brake kinetic rotors directional not that it matters brembo rotors are non directional.
Finish results !!
Got Brembo!!
Brackets from Pkop front and rears. Makes this a simple install.
One side on to the next one!!
Complete and brake pads bedded in. Pad grabs whole machined area of the rotors. Brake kinetic rotors directional not that it matters brembo rotors are non directional.
Finish results !!
#7169
Lead Lap
iTrader: (8)
I had to snap one of my ARP studs to get my wheel off yesterday, so now I have 1 broken stud and a useless project kics wheel lock. I noticed one of the heads on the project kics wasn't spinning freely the last time I installed them. I didn't think anything of it at the time, but I should have known better.
I'm jealous. I've been wanting that brake setup for a while now, but I can't clear them with my wheels.
I'm jealous. I've been wanting that brake setup for a while now, but I can't clear them with my wheels.
The following users liked this post:
Dabiskit (02-25-18)
#7170
Driver School Candidate
iTrader: (1)
^^^^Thanks that sucks that stud broke. Your car looks banging love the look I'm no where as close to you but will one day lol. Slowly but surely I been saving for the brakes took me a few months to get everything. I was going to do tt brake set up got everything then seen the tt calipers are heavier and just as wide the calipers are like just 1/4 inch or so from rim. Glad I went with the Brembos! Now time to start messing with engine upgrades.