im in the process of starting my Na-T setup. The First thing i purchased of a was a Greddy Emanage Ultimate. The next thing i came across was a wastegate a buddy of mine didnt need that was brand new. so i bought it. the thing is that all of the manifolds iv seen have 4 bolt flanges for the wastegate and this one is a 2 bolt.

do i have to resale the wastegate a get a 4 bolt or is there an alternative route that i can take?

 

order the 2 bolt flange, and weld it on in place of the 4 bolt..

 

I sold my Tial for this reason, but mainly because I dont want to pay someone to weld it on. I like the clean-not welded look...but thats going to change with my addition of a FFIM

 

ok i think my wastegate is 8 psi. and i purchased a manual boost controller. will i be able to turn the boost down with that. i have the greddy emanage ultimate for my setup. but after the intstall id probably run like 4 to 5 psi(if i could) until i get it tuned. ive noticed thats how iracemycopcar's car is at the moment. aka pacos car now. so i figured id take that route if its possible.

 

you cannot boost lower than what the spring is rated at. if you want to run 4-5 psi, you need a 4-5 psi spring in your WG..so initially, until your order a new spring, your going to run 8psi, or tune higher with the MBC.

 

i thought that was the case. thanks for the info.