poser714

hey all i was at a local shop here that manufactures parts for a few cars and there happened to be an sc300 there. so i asked them what they were doin to it? they said they were planning and thinking of making some prototype strut bars and chassis/ fender braces for the sc depending on how much demand there is for it. so with that being said i asked them to show me what they had so far and i asked if i could snapped a few shots with my phone. they said it was ok so i could post it up here and see what feedback people have about it




is that a master cycliner stop i see???




and is that a rear strut bar?? that also clears an aftermarket 10 inch sub?? hmmmm...

so far thats all they have but they told me they plan on making a few others and ofcourse fine tuning and tweeking these bars since these are only the prototypes. so tell me what you guys think about these and any feedback i will relay back to them.

Vadim540i

I don't think this will have a lot of demand.

scENFORCER

The rear strut bar might. As far as I know there isint any on the market? I'd at least definatly be intesrested in one..
Also, kinda tough to give an opinion with just pictures. A lot depends on how well these actually work.

Vincent123

iTrader: (24)

what they need to do is make a 3 pt front strut bar, then ppl will buy