When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
A few of my Apex'i GT Spec from a supra. I don't like where it sits now, needs to be a tad higher to fill up the gap in the bumper. nice and quiet on the old 2j, waiting to see how it sounds with a 1J on the other side.
if you want it a tad higher take and wrap a small worm clamp around the exhaust hanger bushing and tightenit till your exhaust sits where you want it. done and done
A few of my Apex'i GT Spec from a supra. I don't like where it sits now, needs to be a tad higher to fill up the gap in the bumper. nice and quiet on the old 2j, waiting to see how it sounds with a 1J on the other side.
if you want it a tad higher take and wrap a small worm clamp around the exhaust hanger bushing and tightenit till your exhaust sits where you want it. done and done
i was going to borrow a torch and bend the hanger up a bit to get a better angle, but i might try this instead as a temporary measure. Thanks!
Originally Posted by Pipe
What size piping did u use?
The piping is a metric, i think it's 90mm. The guy that welded and extended it used 3 in. piping to get it to fit but the diameter is too small. Didn't do a good job welding either...
I want to do mine from the cat back I'm not sure if to use a resonator so I cool down the raspiness that you get with NA cars,I might look for a oval styled barrel to fit the exhaust cut out.
..rite?
