raine

iTrader: (7)

I've seen -10 on another car, half the tire tread is barely skimming the ground. IMO that's not "classy" LOL but hey - whatever floats your boat.

CSPhoto

-10 camber is perfect.

lowlife

u mad bro?

TweakTech

iTrader: (2)

quit creepin the forums and go put these on the car!!! haha, I really wanna see what this is going to look like.

What size tire do you plan on running on these?

Kohinoor

iTrader: (22)

this was my buddy's ls with -7 in the rear... when he drove it was all over the road. contact patch is about half the tire like raine explained.

OG Dada

iTrader: (10)

When I got my SC, it had something like -7 camber at the rear and -5 up front.

Tire wear on brand new tires was 2 months, and the car felt super squirmy going over dips and bumps on the road, and the rear end was all over the place. It's not worth my life, I don't know about yours.

JustChill

iTrader: (9)

19x9 and 19x10 zero offsets all around. will it fit without pulling the fenders? i will be shaving both front and back. what tire size to stretch and fit? ill be on pbm coilovers. and want to tuck some of the tire

raine

iTrader: (7)

If you're going to drive your car like a normal person would, you'll need to pull all four a little bit and stretch, maybe 225/245's with some camber

JustChill

iTrader: (9)

thanks raine, yea this is not my daily so i dont mind having camber. just dont want to pull as much as i did on my last sc..

raine

iTrader: (7)

It shouldn't be a lot of pull at all - especially if you run say, -2 all around before you do the pull

lowlife

I repaint them finaly

elpanda

oh my glob thats nuts lol

menty

19x9.5+12 F
19x10.5+10R

Will it fit???

SCott300

iTrader: (2)

What is the widest tire I can fit on a 19x11 +25 on very little negative camber? I have already rolled the fenders flat, they have a very minor pull, and i have esplier springs on tokico's.
Atleast a 265/30/19 maybe a 275?

assass1n

iTrader: (1)

Here's my current setup 18x10.5 -2 225/40/18 up front and 18x12 +11 255/35/18 in the rear. Fenders are rolled flat. Fenders slightly pulled.