A Measurement
Thread Starter
Pole Position
Joined: Mar 2005
Posts: 263
Likes: 0
From: Texas
A Measurement
I have been looking for the stock measurement for the suspension. I am not even sure what toi ask for. I would like a measurement from the center of the wheel to the bottom of the fender on a stock SC400. Mine is a 1992.
Do you own a tape measure? You could measure this distance presumably as well as me. Plus, my springs may have degraded slightly more or less than yours over the years and my ride may be fractions of an inch higher or lower.
Thread Starter
Pole Position
Joined: Mar 2005
Posts: 263
Likes: 0
From: Texas
Good Gracious!
The reason that I asked for this measurement from a stock setup is because I just put a TEIN Flex set on my car and since the setup was for a Supra, I was wondering what the stock measurement was. please do NOT assume that I am so stupid that I could not do that measurement my self if I still had a stock setup. I should have done this measurement before I did the swap, but since I neglected to do so, I was asking what a stock setup was.
The reason that I asked for this measurement from a stock setup is because I just put a TEIN Flex set on my car and since the setup was for a Supra, I was wondering what the stock measurement was. please do NOT assume that I am so stupid that I could not do that measurement my self if I still had a stock setup. I should have done this measurement before I did the swap, but since I neglected to do so, I was asking what a stock setup was.
I don't know if this helps, but the Tein Flex for the Supra and for the SC have the exact same part number. Presumably, that means there is no difference in the product. Not sure if that helps...
Thread
Thread Starter
Forum
Replies
Last Post
hemogoblin
SC - 1st Gen (1992-2000)
5
Jul 24, 2003 12:36 PM
