My SC recently just got out to the shop after being in there for almost two months. On April 27th a guy pulled out a parking lot and hit my car on the front right side at about the headlight. Anyway the shop had a hard time finding SC parts in the area seeing as there are not many of them. I love that I now have the car back, but the front bumper has two holes for a license plate bracket to go and I do not want to put one on there, but the two holes are kinda ugly looking. My question is there someway to fill this holes in? I would imagine that it would be similar to filling in holes of where emblems once where, so how do you guys do that?

I'm out of town, but I will post a pic when I get back.

 

Go to http://www.bumperplugs.com/. A bit expensive, but can be color matched to many factory colors. Other than that I've heard of using some epoxy and touch up paint.

 

those bumper plugs look like the trunk liner clips...I bought some of those, painted them with touch up paint and slapped em on

 

I think the holes were better. I say have it sanded, glazed and painted. make it look like it theres not supposed to be holes there, not a cover-up

 

how much would this cost? I only have two holes compared to four.

 

A whole lot more than a couple of painted plugs. What color is your car? I think the painted plug route is the way to go. It's cheap and gets the job done. It may not look the best, but at 65mph no one will notice.