PCV vacuum routing?
#2
Lexus Test Driver
I'm guessing some of the how-to's on here will have some photos showing what you need. Maybe search around where they're changing spark plugs. You may see some shots of what you need once that plastic cover is off. Just a thought!
#3
Moderator
Isn't there a vacuum diagram posted in the engine bay?
Salim
Salim
#5
Racer
Thread Starter
Thanks for the pic Baetke, didn't notice that it was that short. Hopefully that barb on the intake plenum is metal so i can resecure the hose with a good clamp when im done with my project.
Admit i haven't looked, but most of my stickers have either peeled up or faded from cleaning chemicals
Admit i haven't looked, but most of my stickers have either peeled up or faded from cleaning chemicals
#6
Pole Position
As I recall, the pipe coming out of the bottom of the intake plenum has a "lip" on it that the hose slides over. There shouldn't be any need for a clamp if you use the right size rubber hose. This line has a vacuum on it so it won't slip off.
#7
Racer
Thread Starter
I'll check for it, on my 02 i use a metal pcv with a rolled lip and the factory uses a light spring clamp on that end. It would make sense that it would have a similar clamp on the plenum side.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
FL1PP3D
Performance & Maintenance
6
10-01-07 12:29 AM