rough acceleration and jerking transmission
Rookie
Joined: Apr 2011
Posts: 55
Likes: 2
From: Tx
mno221,
Two ground wires are bolted to the back of the plenum (top center rear of engine, under the wiper box). Requires a 10MM wrench and agile hands. Reach between the plenum and wiper box (while engine is cool) and you can feel the grounds. They are bolted tight to the plenum, finger length distance from the top.
It's a bit of work, but you could pull the hood and wiper box out; then you can actually see the grounds and connection.
Two ground wires are bolted to the back of the plenum (top center rear of engine, under the wiper box). Requires a 10MM wrench and agile hands. Reach between the plenum and wiper box (while engine is cool) and you can feel the grounds. They are bolted tight to the plenum, finger length distance from the top.
It's a bit of work, but you could pull the hood and wiper box out; then you can actually see the grounds and connection.
Thanks, i'll try that tonight .
Thread
Thread Starter
Forum
Replies
Last Post
murphysf
RX - 1st Gen (1999-2003)
5
Apr 13, 2019 09:32 AM
