When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I got my resistors installed today in the rears. Sure enough hyperblinking is gone and I am a happy camper. Definitely more room to install resistors in the rear area over the front. I ended up using t-taps with no issues.
They had a photo that just convinced me to try them out
Hopefully they work in the front WITHOUT adding another resistor or else I'm gonna have to make some magic happen
I didn't want yellow. Just 5k white light. You are able to get red, yellow, and white I believe.
Not to be the bearer of bad news, but white turn signals will be illegal in all 50 states. You may not get pulled over immediately for it, but it won't pass inspection.
Red/Amber are okay for the rear turn signals, but the front turn signals must be amber legally. You can run switchbacks if it's a dual-filament socket, but it's not legal to run single-filament white.
A non-flashing, white running light will be okay though!
Not to be the bearer of bad news, but white turn signals will be illegal in all 50 states. You may not get pulled over immediately for it, but it won't pass inspection.
Red/Amber are okay for the rear turn signals, but the front turn signals must be amber legally. You can run switchbacks if it's a dual-filament socket, but it's not legal to run single-filament white.
A non-flashing, white running light will be okay though!
Fairly certain it's illegal in Canada as well, but I hope you don't have any issues. It does look good, but that's why switchbacks are a more popular option for turn signals.
Hi, I'm trying to change out my front turn signals. Does anyone have instructions or know how to switch out the bulbs without pulling off the fender liner?
How did you replace them though? The front gives you very little room to work with and I can't find instructions?
you have to turn your front wheels so you can pull back the fender well a little. It’s not that bad but make sure you take your time and put a piece of electrical tap around the bulb and connector to keep it from detaching after installing the led. It happened and it was sitting inside the lens compartment.
I’m going to attempt to swap my factory Amber front bulbs with aftermarket chrome-dipped bulbs (i don’t care to fool with LED’s and resistors etc) this weekend. I will post an update on what did, and how if i have time. Here’s what i ordered :
I’m hoping they fit. I know our bulbs take 7444 but the eBay listing says it doesn’t fit so i don’t know. Could be a base or something that may be off. Hopefully not but i will update.
These worked perfectly without resisters on my 2018
Originally Posted by and3re
Has anyone changed that orange front turn signal bulb into an LED turn signal?
I know the front is a 7444 bulb. But switching to a LED you'd need a resistor?
I hate Splicing the wires and making it look messy,
Is there an ALL WHITE LED you've used that had a resistor already attached?
I've seen them for the rear ( but different bulb size. The rear is a 7440).
Front:
Alla Lighting 7440 7443 LED Amber Yellow Turn Signal Lights Bulbs 7444NAK 7440NAK WY21W Super Bright T20 Wedge 54-SMD 4014 Chipsets Blinker Lamps 12V https://a.co/d/4h5p36Y
Rear:
Alla Lighting CAN Bus T20 7440 7443 LED Bulbs Amber Yellow Turn Signal Lights, 7444NA 7442NA WY27/8W Blinker Lamps Replacement https://a.co/d/11zlEzc
05-28-17, 12:18 PM
