Neo Start Up Throttle questions
#1
Rookie
Thread Starter
Neo Start Up Throttle questions
So I have the apexi neo installed and at cold start, it's fine but if the engine is slightly warm the car stalls unless I blip the throttle a little. At cold the in and out number for the hotwire sensor were 24-24 and that was fine for cold but not warm. Then I tried 13-13 (read it on other builds but all older) and that helped for warm start a little but also idled a bit rough but not for cold. Called apexi and these were the number they said to try as well. I do plan on getting it dyno tuned by a professional within the next week or so but I want to not have these start up issues until then. I zerod the map out so it should act as if the neo isn't installed. Any ideas? what numbers do you have set up?
It's a 03 GS3. K&N drop in and Obx headers with an O2 sim and megan downpipe. It's still fairly stock so I thought it would be easier to start at before more mods later.
It's a 03 GS3. K&N drop in and Obx headers with an O2 sim and megan downpipe. It's still fairly stock so I thought it would be easier to start at before more mods later.
Thread
Thread Starter
Forum
Replies
Last Post