DDDD keep your chrager dont sell it it hahahah u wanna sell it....
RMM Supercharger... Who has the kit?
was a clean GS until someone smashed into it :/ now im stuck with a stock red GS4 that i bought not to long ago.. imma hold of on mods tho... maybe on another gs4...
anyways back on topic!..
anyone else own the kit or know someone that has it (for sure)?
anyways back on topic!..
anyone else own the kit or know someone that has it (for sure)?
ClubLexus Stories
Celebrating Lexus & Toyota from Around the Globe
Top 10 Most Confusing Things Lexus Has Ever Done!
Joe Kucinski
2026 Lexus ES Review: Lexus Re-Embraces Founding Principles
Michael S. Palmer
10 Lexus Bargains That are Cheaper Than a New Toyota RAV4
Joe Kucinski
8 Weirdest Things Lexus Has Ever Built
Verdad Gallardo
10 Lexus Designs That Have Aged Like Fine Wine
Verdad Gallardo
8 Tips for Improving Your Hybrid or Plug-in Hybrid's Efficiency!
Michael S. Palmer
10 Best Lexus Models No One Remembers
Joe Kucinski
TRD Off-Road Premium: Best 2026 4Runner, Except This One Thing
Michael S. Palmer
Top 10 Lexus & Toyotas to Drive Before You Die!
Joe Kucinski
Lead Lap
Joined: May 2008
Posts: 774
Likes: 1
From: california
it not the supercharger that you can get from vortec its the pulley on the power steering pump the billet supercharger bracket and tensioner plus a spacer on the water outlet to clear the belt then all the piping and intercooler. i was looking at the lextreme bracket and it doesn't give clearance for a air filter? highly doubt they will produce these again. because you should also upgrade you connecting rods they have been known to break with boost. and most people wont and then blame rmm for there blown motor....
Lead Lap
Joined: May 2008
Posts: 774
Likes: 1
From: california
connecting rods from piston to crank the early 1uz werent bad but ares are weak look on lextreme they show all of them side by side i was looking at putting some old 1uz rods thicker from 94 ls400..thats the cheapest way i could find..
Lead Lap
Joined: May 2008
Posts: 774
Likes: 1
From: california
yea but i have the small 2.67 pulley going to put the 3.33 back on i am having detonation problems and dont want to break a rod at 10 psi so i am looking into either swapping the whole motor and trans or just rebuilding this motor with lower compression and forged internals. then either putting a r154 or v161 trans in i think a manuel with this set up would be sick....