head gasket question
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2014
Location: texas
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
head gasket question
This may be a stupid question but this is my first sc head gasket. When I go to put the cams back in do I just line the marks up like you do before taking everything apart?
#2
Pole Position
iTrader: (1)
I'm not sure if you have to remove the cams from the head to remove the head from the block.
I know for a fact I removed the 7m head without pulling cams off, but not sure if it's the same with 2j??
But yes line up the timing marks on the cam gear with the marks on the head and make sure your TDC with the crank pulley also need to be on the match marks
I know for a fact I removed the 7m head without pulling cams off, but not sure if it's the same with 2j??
But yes line up the timing marks on the cam gear with the marks on the head and make sure your TDC with the crank pulley also need to be on the match marks
#4
Driver School Candidate
Thread Starter
Join Date: Dec 2014
Location: texas
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
everything I've seen says you have to take them out on a 2jz. Besides the head is getting sent out to be checked before I put it back on so I'm sure they will not be the same when I get it back.
Thread
Thread Starter
Forum
Replies
Last Post