Help - Hydraulic clutch / Input Shaft quesiton
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: TN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Help - Hydraulic clutch / Input Shaft quesiton
Hey Guys,
I don't want to jump the gun and say that I've been had, so I want to check to make sure of a few things.
The T56 style throw out bearing doesn't seem to fit over the input shaft. It's just not going to go without some abusive and possibly destructive tapping. Are people just forcing this on there?
Any options out there for a hydraulic throw out bearing that will work with the 5/8 clutch master cylinder?
In context, this is for a 1uz to W58 swap.
I don't want to jump the gun and say that I've been had, so I want to check to make sure of a few things.
The T56 style throw out bearing doesn't seem to fit over the input shaft. It's just not going to go without some abusive and possibly destructive tapping. Are people just forcing this on there?
Any options out there for a hydraulic throw out bearing that will work with the 5/8 clutch master cylinder?
In context, this is for a 1uz to W58 swap.
#2
Moderator
Was't there cutting of the collar in one of the conversion thread?
Shaft should pass through and the collar is trimmed back.
I would also try to position the slave with the bleeder tube pointing up to purge the air out quicker.
Salim
Shaft should pass through and the collar is trimmed back.
I would also try to position the slave with the bleeder tube pointing up to purge the air out quicker.
Salim
#3
Driver School Candidate
Thread Starter
Join Date: Oct 2012
Location: TN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post