Safc is installed, but I don't know the settings it need for a baseline just to drive it. I believe its hotwire but what is the rest? I just put the turbo on yesterday, running on wastegate (6psi) with the maf in blowthrough, stock fuel. I had everything hooked up and tried driving it home with the stock ecu and it wasn't having it. Had to unhook the IC pipe and run an open maf after resetting the ecu. What am I doing wrong? It goes in for a tune tomorrow but until then I'd like to have it as ready as possible.

 

Nevermind, I figured it out! I had a few wires swapped around, runs good with the afc now.

 

try putting the maf in front of the turbo for best results but you will have to recirculate your bov.