sc300 swap 2jzgte
12-20-11, 08:42 PM
#1
Driver School Candidate
Thread Starter
Join Date: Dec 2011
Location: GA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
sc300 swap 2jzgte
im thinking abt to put 2jzgte motor on sc300 , regular toyota aristo engine complete with ECU, harness, and transmission ...what else i need ? 
12-20-11, 09:08 PM
#2
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
Possible pedals and clutch master if converting to a five speed. Then a clutch, bellhousing flywheel, fork, slave cylinder, and the list keeps on. If keeping stock maybe intercooler piping and some clamps. Maybe. Boost controller, depends on how far you want to go. Stock twins don't have a lot potential over a long time frame. Jmo. GL on your build!
12-20-11, 09:40 PM
#4
Rookie
Join Date: Dec 2011
Location: NC
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
try checking out the stickied post called ★★★ SC300/SC400 FAQ & DIY Mega Links Thread - START HERE! ★★★ in the main forum......
there is a section called "2JZGTE SWAP" with several links and literally a thread labeled "Aristo 2JZGTE swap in SC3! Page 1 has an awesome breakdown of what's needed!"
there is a section called "2JZGTE SWAP" with several links and literally a thread labeled "Aristo 2JZGTE swap in SC3! Page 1 has an awesome breakdown of what's needed!"
Thread
Thread Starter
Forum
Replies
Last Post
